BT50 SPINDLE TAPER WIPER

In Stock

SKU: BT50WIPER

$15.99

BT50 SPINDLE TAPER WIPER

 

Qty
Compare

BT50 SPINDLE TAPER WIPER

MODEL BT50 SPINDLE TAPER WIPER LENGTH 200MM
MATERIAL PLASTIC TAPER SIZE 60.55MM

RELATED BT30 TOOL HOLDER 

SET M12 BT30 SLIM FIT COLLET CHUCK TOOL HOLDER AND 3 MM COLLET G2.5 25000RPM

MODEL BT30 DC06 80  RUN OUT (TIR) 0.00015″ NECK  DIAMETER d1 0.8″
HOLDER TYPE SLIM FIT COLLET CHUCK CLAMPING RANGE  3/32-1/4″ CLAMPING SIZE 3MM
SHANK TYPE BT30 DRAWBAR THREAD M12 X 1.75 DRAWBAR THREAD  M10
BALANCE G2.5 25000rpm GAGE LENGTH 3.15″ COOLANT NO

 

SLIM FIT COLLET CHUCK

High-Speed Cutting (G2.5 25000rpm) Balance

High Precision Runout: TIR  5μm or 0.00015

Hardened:  surface HRC58 inside is HRC45

Protection: silver color

power clamping collet

Easy operate end mill cutter

No clamping nut

 

 

 

 

Drawings

BT30 ER20 COLLET CHUCK TOOL HOLDER

BT30 TAPER TAPER D1 L FLANGE D
DRAWBAR THREAD BT30 M12X 1.75 31.75 70 50

                 

 

 Material Application

a. Quenched and tempered structural steel: The carbon content of this type of steel is generally about 0.25% to 0.55%. For structural parts of a given cross-sectional size, when quenched and tempered along the cross-section during quenching and tempering (quenching and tempering), the mechanics.The performance is good. If the hardening is not penetrated and free ferrite appears in the microstructure, the toughness decreases. For steels with a tendency to temper brittleness, such as manganese steel, chromium steel, nickel-chromium steel, etc., they should be cooled quickly after tempering. The quenching critical diameter of this type of steel increases with the increase in grain size and alloying element content. For example, 40Cr and 35SiMn steel are about 30-40mm, and 40CrNiMo and 30CrNi2MoV steel is about 60-100mm, which is often used in manufacturing Structural parts such as shafts and connecting rods with large loads.cat40 end mill holder

b. Surface hardened structural steel: used to manufacture hard and wear-resistant surface parts and flexible parts, such as gears and shafts. In order to increase the toughness of the core of the part, the carbon content in the steel should be low, generally 0.12 to 0.25%, and there is also an appropriate amount of alloy elements to ensure proper hardenability. Nitrided steel also needs to add alloy elements (such as Al, Cr, Mo, etc.) that are easy to form nitrides. Carburized or carbonitrided steel, after carburizing or carbonitriding at 850~950℃, quenched and used under low-temperature tempering (about 200℃). The nitrided steel is directly treated by nitriding (480~580℃), and it is no longer quenched and tempered.

Weight 2.5 lbs
Dimensions 15 × 45 × 65 in
Measurement system

Inch (in)

Sales Unit

single

Product Category

Spindle Taper Wiper

Tap Size

60.55mm

Holder Type

BT50

Top